Int J Sports Med 1999; 20(8): 532-537
DOI: 10.1055/s-1999-8839
Training and Testing
Georg Thieme Verlag Stuttgart ·New York

Measurement of Maximal Power Output in Isokinetic and Non-Isokinetic Cycling. A Comparison of Two Methods

 R. Baron1 ,  N. Bachl2 ,  R. Petschnig3 ,  H. Tschan2 ,  G. Smekal2 ,  R. Pokan2
  • 1 Institute of Sports Science, Department of Prevention and Rehabilitation and Sports Medicine, University of Vienna, Austria
  • 2 Institute of Sports Science, Department of Exercise Physiology, University of Vienna, Austria
  • 3 Institute for Physical Medicine and Rehabilitation, Donau Hospital, Vienna, Austria
Weitere Informationen

Publikationsverlauf

Publikationsdatum:
31. Dezember 1999 (online)

Preview

The main goal of the study was to compare maximal power output and power output at different pedalling frequencies obtained during isokinetic all-out tests with maximal power output obtained during a single all-out sprint (against the same braking force for every subject). Sixty healthy male subjects participated in the study. The ergometer system used in this study has three operating modes: the isokinetic mode (maintaining pedal crank velocity constant at a present level), a revolution dependent mode and a revolution independent mode. In all three operating modes the effective forces are monitored by means of strain gauge. All subjects performed a single all-out sprint against a braking force of 20 Newton and an all-out isokinetic cycling test consisting of ten 10 s bouts of maximal cycling at speeds ranging from 50 rpm to 140 rpm. In both tests, irrespective of which test mode was used, the mean power for a complete crank revolution showed parabolic relationships to crank velocity. For the isokinetic test, the subjects showed a peak power (IsoWpeak) of 15.3 ± 1.7 W/kg corresponding to an optimal velocity of 115 ± 8.6 rpm. For the force-velocity test NonisoWpeak (the highest power obtained at any time during the test) was 14.4 ± 1.9 W/kg and was achieved at a pedalling rate of 127 ± 14 rpm. IsoWpeak was significantly higher than NonisoWpeak (p < 0.001) but there were no significant differences between NonisoWpeak and IsoWmax (maximal mean power for each full crank revolution) for the revolutions from 90 rpm to 140 rpm. Though, NonisoWpeak and IsoWpeak are significantly different, there was a strong relationship between NonisoWpeak and IsoWpeak (r = 0.7158, p < 0.001). There was also a strong relationship between NonisoWpeak and IsoWmax for the revolutions from 50 rpm to 120 rpm (p < 0.001) and at 130 rpm (p < 0.01).

References

R. Baron

Institute of Sports Science Department of Prevention and Rehabilitation and Sports Medicine University of Vienna

Auf der Schmelz

A-1150 Vienna

Austria

Telefon: +43 (1) 9822661/174

Fax: +43 (1) 9822661/198

eMail: ramon.baron@univie.ac.at