Zusammenfassung
In dieser Studie wurden maschinelle Nickel-Titan-Feilen hinsichtlich ihres dynamischen
Frakturverhaltens in unterschiedlich stark gekrümmten simulierten Wurzelkanälen untersucht.
Insgesamt 440 Feilen wurden bei einem Krümmungsradius von 5 mm bzw. 10 mm bis zur
Fraktur rotiert.
2 Blöcke und Zylinder aus Stahl simulierten gekrümmte Kanäle mit den beiden Krümmungsradien.
Die Zeit bis zur Instrumentenfraktur wurde gemessen. Alle Instrumente frakturierten
im stärker gekrümmten Kanal signifikant schneller als im schwächer gekrümmten Kanal.
Feilen mit größerer Konizität und höherer Instrumentengröße brachen schneller als
kleine Feilen. Den höchsten Widerstand gegen Fraktur wies K3 auf, gefolgt von den
Flexmaster, NiTi-GT-Feilen und ProTaper.
Summary
This study examined the cyclic fatigue behavior of different engine-driven NiTi endodontic
files in differently curved artificial canals. The artificial canals were mounted
on an electronically controlled table to allow exact placement. Time until fracture
was recorded. As curvature increased time until fracture decreased significantly.
Files of higher taper and larger size showed an increased fracture risk when operated
in a curved canal. The K3 files showed the best resistance to fracture followed by
Flexmaster, NiTi GT and ProTaper.
Schlüsselwörter
Nickel-Titan - maschinelle Aufbereitung - Fraktur - Krümmungsradius - Konizität
Key Words
Nickel-Titanium - Rotary Preparation - Fracture - Radius of Curvature - Conicity
Literatur
1
Walia H, Brantley WA, Gerstein H.
An initial investigation of bending and torsional properties of nitinol root canal
files.
J Endod.
1988;
14
346-351
2
Tepel J, Schäfer E, Hoppe W.
Properties of endodontic hand instruments used in rotary motion. Part 3. Resistance
to bending and fracture.
J Endod.
1997;
23
141-145
3
Friedman S, Stabholz A.
Endodontic retreatment - case selection and technique. Part 1: Criteria for case selection.
J Endod.
1986;
12
28-33
4
Hülsmann M, Schinkel I.
Influence of several factors on the success or failure of removal of fractured instruments
from the root canal.
Endod Dent Traumatol.
1999;
15
252-258
5 International Organization for Standardization. .In: Book International Organization
for Standardization. Vol. 3630-1. Series International Organization for Standardization
1992
6 Revised American National Standards Institute/American Dental Association. Series
American Standards Institute: Revised American National Standards Institute/American
Dental Association 1988 28c
7
Haikel Y, Serfaty R, Bateman G, Senger B, Alleman C.
Dynamic and cyclic fatigue of engine-driven rotary nickel-titanium endodontic instruments.
J Endod.
1999;
25
434-440
8
Peters O, Laib A, Rüegsegger P, Barbakow F.
Three dimensional analysis of root canal geometry using high resolution computed tomography.
J Dent Res.
2000;
79
1405-1409
9
Peters OA, Schönenberger K, Laib A.
Effects of four Ni-Ti preparation techniques on root canal geometry assessed by micro
computed tomography.
Int Endod J.
2001;
34
221-230
10
Dederich DN, Zakariasen KL.
The effects of cyclical axial motion on rotary endodontic instrument fatigue.
Oral Surg.
1986;
61
192-196
11
Li U-M, Lee B-S, Shih C-T, Lan W-H, Lin C-P.
Cyclic fatigue of endodontic nickel-titanium rotary instruments: Static and dynamic
tests.
J Endod.
2002;
28
448-451
12
Zelada G, Varela P, Martin B. et al. .
The effect of rotational speed and the curvature of root canals on the breakage of
rotary endodontic instruments.
J Endod.
2002;
28
540-542
13
MCC deMelo, MG deAzevado Bahia, VTL Buono.
fatigue resistance of engine-driven rotary nickel-titanium endodontic instruments.
J Endod.
2002;
28
765-769
14
Peters OA, Kappeler S, Bucher W, Barbakow F.
Maschinelle Aufbereitung gekrümmter Wurzelkanäle: Messaufbau zur Darstellung physikalischer
Parameter.
Schweiz Monatsschr Zahnmed.
2001;
111
843-852
15
Camps J, Levallois B.
Relationship between file size and stiffness of nickel titanium instruments.
Endod Dent Traumatol.
1995;
11
270-273
Korrespondenzadresse
PD Dr. Rudolf Beer
Fakultät für Zahn-, Mund- und Kieferheilkunde
Universität Witten/Herdecke
Abteilung für Konservative Zahnheilkunde
Alfred-Herrhausen-Str. 50
58448 Witten
Email: rudolf@dres-beer.de