Open Access
CC BY-NC-ND 4.0 · Eur J Dent 2010; 04(03): 293-297
DOI: 10.1055/s-0039-1697842
Original Article
European Journal of Dentistry

Solvent Retention of Contemporary Commercial Dentin Bonding Agents in a Demineralized Dentin Matrix

Georges Garcia
a   Restorative Dentistry of University North of Paraná – UNOPAR, Londrina, PR, Brazil
,
Karen Barros Parron Fernandes
a   Restorative Dentistry of University North of Paraná – UNOPAR, Londrina, PR, Brazil
,
Fernanda Cristina Pimentel Garcia
b   Faculty of Ceilândia, University of Brasilia-UnB, Ceilândia-DF, Brazil
,
Paulo Henrique Perlatti D’Alpino
c   Department of Restorative Dentistry, GEO/Bandeirante University of São Paulo, São Paulo, SP, Brazil
,
Nádia da Rocha Svizero
d   Department of Operative Dentistry, Endodontics and Dental Materials of the School of Dentistry of Bauru, University of São Paulo, Bauru, SP, Brazil
,
Linda Wang
d   Department of Operative Dentistry, Endodontics and Dental Materials of the School of Dentistry of Bauru, University of São Paulo, Bauru, SP, Brazil
› Author Affiliations
Further Information

Publication History

Publication Date:
30 September 2019 (online)

Preview

Objectives: Solvents are ingredients in dentin-bonding agents (DBAs) that are essential to obtain efficient adhesion to dentin under wet-technique bonding protocol. However, an excess of solvents can compromise bonding durability. This study aimed to assess the retention of solvents present in different DBAs after their application to a demineralized dentin matrix.

Methods: Thirty-six specimens of bovine dentin were demineralized for 7 days in 0.5M EDTA and divided into six groups n=6 (Scotchbond primer, Adper Single Bond 2, Excite, AdheSE primer, Prime & Bond NT and Xeno III). These specimens were individually saturated by the systems for 5 min and then kept in vials protected against light exposure. Each specimen was measured using a digital balance and then measured at the following intervals 10, 20, 30 sec, 1, 2 and 5 min thereafter. Data were analyzed by two-way ANOVA and Tukey tests (alfa=.05).

Results: There were significant differences evident in Excite, Prime & Bond NT at 2 and 5 min, respectively. There was no significant interaction between materials and time in all experimented time evaluated. The amount of solvent spontaneously evaporated was limited even in acetone-based specimens.

Conclusions: After DBAs are applied, professionals may facilitate their evaporation, since spontaneous evaporation is limited. (Eur J Dent 2010;4:293-297)